Plasma Cutter - 70 A - 400 V - pilot ignition

Powerful plasma cutter with pilot ignition and 70 A

The plasma cutter S-PLASMA 70-IGBT from stamos_germany with modern IGBT inverter technology cuts electroconductive materials such as steel, stainless steel, cast iron, copper, nickel and aluminium precisely and without distortion. The professional device enables you to make cuts up to max. 20 mm deep at a cutting output up to 70A and is perfect for repair and renovation work in workshops or garages.

Plasma cutter with high operating comfort

The cutting current can be adjusted between 30 and 70  A, and all values are clearly shown on the LCD display. At a duty cycle of 100 %, a high 44 A is still possible. These performance values are sufficient to cut workpieces up to 20 mm thick. The plasma cutter can cut tool steels as well as stainless steel and other high-alloy steels. Even aluminium, copper and titanium can't resist the powerful plasma arc of the S-PLASMA 70-IGBT.

The plasma cutting machine offers two different working modes so that maximum progress can be achieved with every task. In 2-stroke mode, the torch will run for as long as the power switch is pressed. In 4-stroke mode, a single tap is sufficient to activate the burner and another tap to switch it off.

The plasma cutter from stamos_germany works with three-phase alternating current at an operating voltage of 2 V. This makes it the perfect tool for automotive workshops, commercial metalworking operations and industrial production. In addition, it also supports DIY enthusiasts in their demanding renovation and repair projects.

The torch is ignited via a pilot plasma arc, which can also be used to separate grids and grates. You can select the external compressor according to requirements and conditions and set the air pressure for plasma cutting via the external pressure reducer. Thus, the device proves to be very flexible and easy to transport. To prevent oxidation or deformation on the workpiece after a cut, the air supply runs on for 10 seconds. The air run-on also cools the torch and prevents the risk of damage. The base unit is also equipped with powerful fan cooling to prevent overheating. If the operating temperature nevertheless rises excessively, the overheating protection comes into play.

The compact steel housing protects the technical equipment inside the plasma cutting machine. From the outside, it is protected from environmental influences with a coating. The plasma cutter is easy to transport thanks to the practical handle.